| Author | Comment |
Seydagorg
Probe
Posted: 21 Oct 2005
15:58 GMT
Total Posts: 2 | My TI Connect cannot read my TI-84+SE, I have followed the steps as they asked me to... Also, I believe that it might be because it tries to connect to COM 1 when even when I specify the device... it still only says COM1 while searching for my calculator.
I would really like help with this...
Me! |
JcCorp
Probe
Posted: 21 Oct 2005
17:17 GMT
Total Posts:
Edit | It sounds as if you didn't install the driver correctly... try putting in the USB device with the CD and when Windows XP (which I'm assuming you have... say otherwise) has that little bubble in the corner, have it install the driver, and try again. Otherwise, I would try installing the newest version of TI-Connect. |
TI Freak
Probe
Posted: 21 Oct 2005
19:50 GMT
Total Posts:
Edit | Are you using the usb direct link? If that is the case, I have seen alot of people have troubles with that link... |
Seydagorg
Probe
Posted: 21 Oct 2005
21:39 GMT
Total Posts: 2 | I think so... Well, that sucks. I wanted to actually use my calculator for more than a expensive notepad... |
JcCorp
Probe
Posted: 22 Oct 2005
04:18 GMT
Total Posts:
Edit | Don't give up hope! If nothing works, contact TI! |
TI Freak
Probe
Posted: 22 Oct 2005
06:01 GMT
Total Posts:
Edit | Or go to staples and buy the silver link... |
